Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent U-Line specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 581-3724 Set Up a Visit
Model library · U-Line Ice Machine

BI2015

U-Line BI2015 15-Inch Built-In Ice Maker Repair

U-Line ice maker model

Most common issues on this model

  1. Ice production slowing because the water inlet valve is restricted
  2. Drain pump or line blocked with scale, leaving water in the base
  3. Scale film on the evaporator that traps cubes in the grid
  4. Bin thermostat not shutting off the ice cycle
  5. Condenser airflow reduced by dust at the front grille

The BI2015 is a 15-inch built-in ice maker from the first generation of the Echelon 2000 line, installed beneath a counter in a kitchen, bar or basement and connected to a water line and a drain. It has been making ice for a long time, and the work it needs is the work that every older ice maker needs.

Water is the main cause. Scale narrows the inlet valve, coats the evaporator and clogs the drain, and the unit makes smaller batches while the pan holds standing water. Dust at the grille raises the temperature of the condenser, which slows freezing.

We check the supply and valve, descale the water path, clear the drain, test the bin thermostat and clean the grille and coil. The 15-inch cabinet leaves little room, so we slide it out only as far as needed. Your price is written before any part is ordered, and repairs carry a 30-day warranty.

Key features

  • Early Echelon 2000 ice maker
  • Undercounter placement
  • Designed to run on a water line and a drain
  • Water supply and drain connected behind the cabinet
→Codes

Error codes this model can show

BI2015BI2015 questions
Why is my BI2015 making less ice than before?

Scale in the water path and a dusty condenser both slow production. We descale, clear the valve screen and clean the coil, then time a full cycle to confirm the batch size.

Why is water sitting in the bottom?

The drain is partly blocked, or the pump is clogged with scale. We clear the line and test the pump so water leaves after each cycle.

What does the bin thermostat do?

It stops ice making once the bin is full. If it fails, the unit overfills or stops early, so we test it with a probe on every visit.

Book a visit

Book repair for your BI2015

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

☎ Call the desk ▤ Set Up a Visit