U-Line CLR2060 One flash: overflow protection circuit open

What CLR2060 one flash means

On the U-Line CLR2060 clear ice machine, which uses the first-generation Echelon board, one flash of the board LED means the overflow protection circuit is open. This applies only to units equipped with the P-60 pump. The circuit shuts the machine down to prevent water overflow, so ice making stops until the condition clears. You see the LED blink once, pause and repeat, and no new ice is made while it does.

Common causes of CLR2060 one flash

An overflow protection circuit that reads open
Water level high enough to trip the protection
A drain pump problem on a P-60 equipped unit

✓ One safe check you can try

1. Unplug the machine and wait a minute. 2. Check that the drain line is not kinked and drains freely. 3. Remove excess water from the bin if any is standing. 4. Restore power and watch the LED. 5. If you see one flash again, call us.

! Why to stop there

Overflow protection involves water and electrics together
The P-60 pump circuit needs testing
Resetting without finding the cause allows a repeat

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Ice Machine codes

Ice / Off scrolling with SPU-Line Echelon 2000 Message "Ice / Off scrolling with SP": ice maker off mode CLU-Line Echelon 2000 Message "CL": self-cleaning cycle running CLR2060 two flashesU-Line CLR2060 Two flashes: open thermistor or too warm CLRCO2075 LED 2 flashingU-Line CLRCO2075 LED 2 flashing: open thermistor CLRCO2075 LED 3 flashingU-Line CLRCO2075 LED 3 flashing: drain pump blocked or overloaded E6U-Line Ice Machine Code E6 Reads Sensor 2 as Shorted E7U-Line Nugget Ice Machine Code E7: Third Sensor Shorted E8U-Line Ice Machine Code E8: Fourth Sensor Shorted

CLR2060 one flashCLR2060 one flash questions

Does one flash apply to every CLR2060?

Only to units with the P-60 pump. Machines without it do not use this overflow protection circuit. Units without the P-60 pump never show it.

Does one flash mean a leak?

It means the protection circuit is open to stop an overflow. Check the area for water, and keep the drain line clear. Look under the machine for water.

How do I clear it?

Interrupting power resets the machine once the cause is cleared. If one flash returns, call us for the pump and circuit test. Price in writing first.