U-Line first-generation Echelon Board LED steady: control has power

What Board LED steady means

On first-generation U-Line Echelon refrigerators with the 2075 or 2015 control board, such as the 2075R, the 2015R and the CLR2060, a steady board LED means the control board has power and operation is normal. It is the healthy state, not an error. You see the LED lit and unchanging, with no flashing pattern. The pattern needs no action unless cooling is poor, in which case the cause lies outside the board.

Common causes of Board LED steady

Normal operation with power at the board

✓ One safe check you can try

1. Treat a steady LED as normal. 2. If the unit is not cooling anyway, check that the plug is seated and the breaker is on. 3. Look at the door seal and the front grille for dust. 4. Note whether the LED starts to flash. 5. Call us if cooling is poor with a steady LED.

! Why to stop there

A steady LED means the board itself is fine
A cooling problem with a steady LED lies elsewhere
We diagnose that on a visit, not by reading the LED

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Refrigerator & Drawers codes

E9U-Line Echelon 2000 Code E9: Thermistor 4 (condenser) open or shorted ER (alternating with SP)U-Line Echelon 2000 Message "ER alternating with SP": error summary display Flashing degree symbol / snaking charactersU-Line Echelon 2000 Display: flashing degree symbol means showroom mode SPU-Line Echelon 2000 Display "SP": normal set-point readout E5U-Line Echelon 2000 Code E5: Thermistor 1 reading 10 F above set point E5U-Line Origins 1000 Code E5: Temperature 10 degrees above set point for 6 hours E6U-Line Echelon 2000 Code E6: Thermistor 1 reading 10 F below set point E6U-Line Origins 1000 Code E6: Temperature 10 degrees below set point for 6 hours

Board LED steadyBoard LED steady questions

What does a steady LED tell me?

The control board has power and reports normal operation. No sensor or heat problem is detected, so no flashing pattern appears. Flashing is the signal to act.

The LED is steady but the unit is warm. What now?

The board is fine, so the cause sits in cooling, airflow or the door seal. Clean the grille and check the gasket, then call us if it stays warm.

Do I need a repair for a steady LED?

No. A steady LED is the normal state. A repair is needed only if it begins to flash or the temperature drifts from the set point. Call us if the temperature drifts from the set point.