U-Line CLR2060 Two flashes: open thermistor or too warm

What CLR2060 two flashes means

On the U-Line CLR2060 clear ice machine with the first-generation Echelon board, two flashes of the board LED mean an open thermistor or a reading out of range because the machine is too warm. Three flashes means both conditions exist. Only interrupting power clears the codes; the ON/OFF/CLN switch does not. You see two blinks, a pause and a repeat, and the machine stops making ice until power is interrupted.

Common causes of CLR2060 two flashes

A thermistor that is open
A machine running too warm
Both conditions together, shown as three flashes

✓ One safe check you can try

1. Check the clearance around the machine and the room temperature. 2. Clean the grille and vents. 3. Interrupt power for a minute, because the ON/OFF/CLN switch does not clear it. 4. Restore power and watch the LED. 5. If two or three flashes return, call us.

! Why to stop there

An open thermistor needs a meter test
A warm reading needs a cooling check
Switching ON/OFF/CLN will not reset it

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Ice Machine codes

Ice / Off scrolling with SPU-Line Echelon 2000 Message "Ice / Off scrolling with SP": ice maker off mode CLU-Line Echelon 2000 Message "CL": self-cleaning cycle running CLR2060 one flashU-Line CLR2060 One flash: overflow protection circuit open CLRCO2075 LED 2 flashingU-Line CLRCO2075 LED 2 flashing: open thermistor CLRCO2075 LED 3 flashingU-Line CLRCO2075 LED 3 flashing: drain pump blocked or overloaded E12U-Line Nugget Ice Machine Code 12: Reservoir Water Level Low E13U-Line Nugget Ice Machine Code E13: Auger Error P1U-Line Nugget Ice Maker Code P1: Pump Circuit Open

CLR2060 two flashesCLR2060 two flashes questions

Does the ON/OFF/CLN switch clear the code?

No. Only interrupting power clears two flashes or three flashes. Unplug for a minute or switch off the breaker. Pulling the plug for a minute works.

What does three flashes mean?

Three flashes shows both conditions together: the thermistor is open or out of range, and the machine is too warm. Each condition is checked separately on a visit.

What do you do on a visit?

We test the thermistor, check airflow and cooling, repair what is found and confirm the LED stays steady. Written price first and a 30-day warranty.