U-Line BI95 Legacy Icemaker Repair
The BI95 comes from the legacy numbering, with the 95 cabinet code and the BI prefix for built-in. It makes crescent ice in a harvest cycle and shuts off with a mechanical bin-full lever instead of a sensor, so its behavior is easy to read once you know where to look.
A machine this age runs on moving parts. The harvest motor turns every cycle and eventually wears. The inlet valve that fills the mold stops closing fully and drips, flooding the mold and producing slush. The bin lever rides in a mounting that corrodes and sticks, and a stuck lever either never lets production start or never lets it stop.
We test the motor, the valve and the lever first. We quote in writing before anything is replaced, and the repair is covered for 30 days.
The bin-full lever is stuck in the up position. We free and clean its pivot, replace it if it is bent, and test a full cycle to confirm production starts and stops correctly.
A valve that does not close drips into the mold between cycles. We test it and replace it if it leaks, then run a harvest to confirm the cubes release cleanly.
The harvest motor has worn. We check its gear and winding, replace the motor if it fails the test, and confirm the cubes drop into the bin on a full cycle.
Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.
