U-Line CO29A Legacy Ice Maker Combo Repair
The CO29A is an ice maker combination from the older 29 series, installed under a counter in a bar, a garage kitchen or a family room. It is a legacy design with a water line and a drain connected behind it, and those two connections are where most of our calls begin.
Water leaves scale in the valve, on the tray and in the drain, and the result is smaller batches and a pan that does not empty. A cabinet that shares its cold with an ice maker also frosts faster when the seal fails, so we look at the gasket as closely as we look at the plumbing.
We check the water supply and the inlet valve, clear and flush the drain, descale the ice tray, test the gasket and clean the condenser. We quote the job in writing before ordering parts, and the finished repair is warranted for 30 days.
Scale in the inlet valve or tray limits water flow, and a dusty condenser slows freezing. We descale, clear the valve screen and clean the coil, then time a full cycle.
The drain line is blocked or has lost its slope. We flush the line and confirm water leaves the pan after each harvest, so the pan stays dry between cycles. We also check the line for a sag.
Yes, it needs a clean supply and a drain. We check the line and fittings for kinks or leaks during the visit, and we flag anything that restricts flow. A restricted line is a common cause of slow ice.
Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.
